Custom Gt lowering axle blocks
-
I machined a set of lowering custom axle adapters to mount a Superflux or XR/Plus motor.
These blocks lower the stock rails by 1/2 inch, but that little bit makes a big difference in the feel of the board, less "tippy".
-
@lemur those look really good
-
@lemur These are so cool. Ever planning on selling a set? I may be in the market for some :3
-
@lia Possibly, I will let you know. You have a stock GT/motor?
-
@lemur Planning on a superflux ^-^ No stock motor.
-
@lia Are you going to vesc or stock GT controller with your SF?
-
@lemur Stock for now. I have a GT with no motor or pads currently.
-
@lia If you go with Sf motor it will require internal motor mods to make it compatible with the GT controller, axle adapters and appropriate phase/hall connectors. I can send you instructions for motor mods if you go that route.
You can also use a XR/Plus motor too with just axle adapters and appropriate phase/hall connectors. -
@lemur I've given it some thought and I might take a swing at making an alternative daughterboard for the GT to accept the new Superflux V2 connector. Gonna be very DIY and hands on but a nice clean solution if I can pull it off.
Gotta finish a few other things up first. The new XR based controller housing for Fungineers is nearing completion so I should have some time after that to give it a swing.
