Navigation

    The Onewheel Forum

    Onewheel Forum

    • Register
    • Login
    • Search
    • Categories
    • Recent
    • Popular
    • Users
    • Groups
    • Rules
    • Archive

    XR battery dead after 4km, any ideas?

    Repair
    2
    20
    950
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • B
      BulleTxTimE @Lia last edited by

      @lia I'll check the wires again. Also I test the total battery voltage and it gave me 43.4V even though the OW app said 100%...

      Lia 1 Reply Last reply Reply Quote 0
      • Lia
        Lia GT XR Pint Plus V1 DIY @BulleTxTimE last edited by

        @bulletxtime 43.4v is really low for an XR! Like that's below the low voltage cutoff for the 15 series cells all together. 43.4/15=2.89v per cell. 3v is the cutoff.

        Each cell should be anywhere between 3v and 4.2v. Together in series between 45v and 63v.

        A new battery is probably the safest bet. If you want to dig deeper you could probe the balance connector between cells to see if it's a single bank of cells that just died or the whole pack is bad in which I would assume the BMS might not be good.

        Did all the parts definitely come from an XR and not a Plus?

        B 2 Replies Last reply Reply Quote 0
        • B
          BulleTxTimE @Lia last edited by

          @lia I tried plugging the OWIE chip to PC but I get nothing. I think it's dead.

          1 Reply Last reply Reply Quote 0
          • B
            BulleTxTimE @Lia last edited by BulleTxTimE

            @lia here is a reading of all the cells from the balance connector:

            C1 = 2.68
            C2 = 3.06
            C3 = 2.64
            C4 = 3.06
            C5 = 2.70
            C6 = 3.05
            C7 = 3.07
            C8 = 3.09
            C9 = 3.08
            C10 = 2.70
            C11 = 2.71
            C12 = 3.05
            C13 = 2.70
            C14 = 3.07
            C15 = 2.70

            I'm sure the battery (it says 15s2p on it) and controller (the app shows it as XR) came from an XR. The BMS I bought with the controller but the guy also gave me a set of OW+ rails. Could it be that the BMS was from a OW+ and that's why it doesn't charge?

            1 Reply Last reply Reply Quote 1
            • B
              BulleTxTimE @Lia last edited by

              @lia So I checked the wires of the owie chip twice. I also pressed reset on it why trying to connect it to my phone because it wasn't blinking.

              I then decided I would cleanup my wires and replaced a bunch of Frankenstein wires. Plugged everything back in without the owie chip and now the board correctly shows 1%... I have no idea why it was showing 100% before and now 1%. It's charging now so I'll let it fully charge for a few days and I will update.

              Lia 1 Reply Last reply Reply Quote 1
              • Lia
                Lia GT XR Pint Plus V1 DIY @BulleTxTimE last edited by

                @bulletxtime That's some good news! Hope you can get those cells back above LVC :)
                Do you have a pic of the BMS in question. Just so I can see if it is the right one. I'm sure it is since you'd run into all sorts of other compatibility issues long before riding but good to check.

                B 1 Reply Last reply Reply Quote 1
                • B
                  BulleTxTimE @Lia last edited by

                  @lia Of course! It's charging so I didn't unplug anything. Will take better pics later if needed.!

                  IMG_1185 Large.jpeg IMG_1184 Large.jpeg

                  Lia 1 Reply Last reply Reply Quote 1
                  • Lia
                    Lia GT XR Pint Plus V1 DIY @BulleTxTimE last edited by

                    @bulletxtime Yeah that one's fine :) Definitely not a plus BMS thankfully.

                    Fingers crossed it works out fine!

                    B 1 Reply Last reply Reply Quote 1
                    • B
                      BulleTxTimE @Lia last edited by

                      @lia I'll keep you posted! Thanks for your help.!!

                      Lia 1 Reply Last reply Reply Quote 1
                      • Lia
                        Lia GT XR Pint Plus V1 DIY @BulleTxTimE last edited by

                        @bulletxtime Welcome ^-^

                        B 1 Reply Last reply Reply Quote 1
                        • B
                          BulleTxTimE @Lia last edited by

                          @lia Alright, after charging to 100%, here are the new cell readings:

                          C1 = 4.08
                          C2 = 4.10
                          C3 = 4.08
                          C4 = 4.10
                          C5 = 4.08
                          C6 = 4.10
                          C7 = 4.10
                          C8 = 4.10
                          C9 = 4.10
                          C10 = 4.09
                          C11 = 4.09
                          C12 = 4.10
                          C13 = 4.09
                          C14 = 4.10
                          C15 = 4.09

                          Total 61.5

                          Would you consider this balanced?

                          Lia 1 Reply Last reply Reply Quote 2
                          • Lia
                            Lia GT XR Pint Plus V1 DIY @BulleTxTimE last edited by

                            @bulletxtime That's balanced enough. There is a little cell degradation since they should peak at 4.2 but that's expected for an old used battery so I'd say that's good to ride! :)

                            1 Reply Last reply Reply Quote 2
                            • First post
                              Last post