XR rear LED Pinout

[peepermeeper]

Does anyone know this? Id like to use it with the thor300 if possible

[Lemur]

The red leds use orange for positive and grey for negative
The white leds use yellow for positive and magenta for negative .
I'm not sure you can use the Xr rear light strip for Thor as I believe the Thor light controller is for rgb(w) .

[peepermeeper]

@lemur Thank you !! and I think you are right about that I'm going to go with something else!

[LOAFFETTE]

@lemur do you by any chance know what voltage the LEDs run at?

[Lemur]

@loaffette I can't remember, but I believe each color runs at a different voltage.
I will find out and let you know.

[LOAFFETTE]

@lemur alright, thank you!

[Sirgu]

@Lemur said :

... , but I believe each color runs at a different voltage.
I will find out and let you know.

I'm also curious and following this.

[Lemur]

@loaffette The red leds run bright at 8v and the white leds run at 14v on my variable power supply. Although they can run a volt or two higher, but 8v and 14 volts are safe

[LOAFFETTE]

@lemur so idealy I could run the white LEDs at 12V?

[Lemur]

@loaffette 12 volts may be too dim as when the Xr boots up, the white leds voltage shoots up to 18v and drops down to 16v. I mentioned 14 v just to be on the low side.

[LOAFFETTE]

@lemur damn, got it
thank you