Posts made by BulleTxTimE

@lemur Absolutely! This is a big Win for consumers. Fantastic news.

@lia Alright, after charging to 100%, here are the new cell readings:

C1 = 4.08
C2 = 4.10
C3 = 4.08
C4 = 4.10
C5 = 4.08
C6 = 4.10
C7 = 4.10
C8 = 4.10
C9 = 4.10
C10 = 4.09
C11 = 4.09
C12 = 4.10
C13 = 4.09
C14 = 4.10
C15 = 4.09

Total 61.5

Would you consider this balanced?

@lia I'll keep you posted! Thanks for your help.!!

@lia Of course! It's charging so I didn't unplug anything. Will take better pics later if needed.!

@lia That's great news TBH!

@lia So I checked the wires of the owie chip twice. I also pressed reset on it why trying to connect it to my phone because it wasn't blinking.

I then decided I would cleanup my wires and replaced a bunch of Frankenstein wires. Plugged everything back in without the owie chip and now the board correctly shows 1%... I have no idea why it was showing 100% before and now 1%. It's charging now so I'll let it fully charge for a few days and I will update.

@lia here is a reading of all the cells from the balance connector:

C1 = 2.68
C2 = 3.06
C3 = 2.64
C4 = 3.06
C5 = 2.70
C6 = 3.05
C7 = 3.07
C8 = 3.09
C9 = 3.08
C10 = 2.70
C11 = 2.71
C12 = 3.05
C13 = 2.70
C14 = 3.07
C15 = 2.70

I'm sure the battery (it says 15s2p on it) and controller (the app shows it as XR) came from an XR. The BMS I bought with the controller but the guy also gave me a set of OW+ rails. Could it be that the BMS was from a OW+ and that's why it doesn't charge?

@lia I tried plugging the OWIE chip to PC but I get nothing. I think it's dead.

@lia I'll check the wires again. Also I test the total battery voltage and it gave me 43.4V even though the OW app said 100%...

@lia So I installed the owie chip but now I get an error 16. I did not have that without the chip. Not sure how to fix it..

@lia thanks for your reply! I'm very confortable taking it appart. I was planning to measure the cell voltage next as part of the diagnostic process but wanted to ask the pros before doing anything. I'll get on it right now, I also have an owie chip that I have on hand that I will be installing for deeper stats. Will update with results!

@lia hi Lia! Unfortunately it's a hardware/firmware configuration that won't allow it. Here's an update, I charged the board for the past 72h to balance the cells and went for a test ride, I could not go more than 100 metres before I got the "Need some juice" message.

Hey, I put together a Onewheel XR from spare parts of about 4 different boards due to budget constraints.

I finally finished the build and was super happy to ride it just to find out that after just 4km the boards tells me it needs to be charged. I rode past pushback at very low speed and the board cuts off after a few meters. If I open the app, the board shows the battery at 85%. My firmware/hardware configuration doesn’t show battery voltages.

Any idea what could be the problem?