@studentde Job done. I enjoyed that.
I hope you can use it constructively. Thanks.

IMG_20250419_005034.jpg

@lemur very wise words re backup and is of course exactly what I didn’t do. Lesson learned!

It seems I have a very narrow sweet spot within which to engage the motor, which is easy to overshoot. Will get a sure start. Thanks for you help.

@deeph Oh this might be a later model board where they removed that data :/
Give it a balance charge overnight and see if it improves much. Over time of leaving it a little longer after you see green you may claw back some range.

@lia Thanks for the reply!

@lia Thank you, I’ll try.

@lia hiya, thank you so much for your detailed and helpful reply! I will have a look into everything you've said. I'll do a bit of reasearch into fixing it myself, and see how I feel about that first. Sounds like there are a few options there, so that's good to know!

Thanks again :)

@lia Thank you!

@imgermg If you can turn on the board you may be able to use the OWCE app to check voltage.
https://owce.app/install

If not the only other way to measure is to take it apart and measure with a multimeter at the battery connector.
I have labelled the 2 pins you can measure without unplugging the battery but be careful not to short them.
3530d501-383b-426c-b668-51187345068c-image.png