@lemur thank you! The pint is slightly different but I was able to see than 4 out of the 6 MOSFET were blown. Took them off my board and no longer have a short. Just need my replacements now :)

@lemur yes I believe so. When I measure the resistance I get approx. 850 ohms from the source to the drain. When the new mosfets are installed the diode mode shows voltage in both directions (source to drain and drain to source). I’m just trying to figure out what else could be blown causing these readings.

@lemur thanks for the reply! I removed the mosfets and noticed that on Q2 the source and drain are still short. Do you have an idea what component could be causing the short still? It is only in this location and it doesn’t appear that I have any solder bridges.

@lemur thank you! The pint is slightly different but I was able to see than 4 out of the 6 MOSFET were blown. Took them off my board and no longer have a short. Just need my replacements now :)

@lemur how did you test the MOSFET? Something in my controller is causing a short but I don’t know how to test the MOSFET. Any tips would be awesome!